Parkside PARS 4 A1 Bedienungs- Und Sicherheitshinweise Seite 26

˜ Changing screw bits
(Fig. D)
NOTE
A built-in magnet on the bottom of the bit holder
u
the inserted screw bit
Screw bits
u
and their shape. The screw bit has to snugly fit in the screw
head .
Pull out the screw bit
o
the bit holder
˜ Setting the torque
(Fig. C)
Press the torque control button
o
torque .
3 torque levels are available (see following table).
o
The LED indicator lights
o
following table).
NOTE
The values in the following table are for reference only .
u
Do not rely solely on these values if high precision work is
required .
The listed driving torque value is measured by the
u
static load test method . This is the maximum torque,
corresponding to level 1 to 3, to drive a screw into wood .
The product stops driving the screw once the set torque
u
has been reached .
26 GB/IE/NI
.
8 ] [
are labelled according to their dimensions
8 ] [
. Insert another type of screw bit into
8 ] [
.
1 ] [
4 ] [
repeatedly to set the
[ 5 ]
indicate the set torque (see
holds
1 ] [