7.8 Phases of the moon / tides
The base station shows you the current phase of the moon (3) by
means of the following symbols:
Display
Tides:
H = High tide
M = Mid-tide
L = Low tide
Phase of the moon
New moon
Half moon waxing
Half moon
Full moon waxing
Full moon
Full moon waning
Half moon
Half moon waning
7.9 Min/Max temperature / ambient humidity alarm
Setting Min/Max values
• Press the ALERT button (E) for around 3 seconds until the
outdoor temperature starts to ash.
• The temperature display ashes for around 20 seconds. Pressing
the arrow keys (B) or (C) allows you to rst set the maximum
value (HI) and then the minimum value (LO).
• By pressing the ALERT button (E) again, you can select the
respective value.
• Repeat the steps for the ambient humidity.
• When a maximum or minimum value is reached, the display
ashes and a 5-second alarm sounds every minute.
• To end the alarm, press the ALERT button (E) once.
Deactivating / activating the alarm
• Press the Alert button once brie y and the "HI" maximum value
starts to ash. Pressing the arrow key allows you to activate or
deactivate the alarm. An activated alarm is indicated by a small
alarm symbol. Repeat the steps for the minimum value "LO".
7.10 Barometer
Display of the absolute air pressure for precise monitoring of
weather changes.
The built-in barometer collects the changes in air pressure over the
last 24 hours and displays these in graphic form. You can choose
between hPa and Hg as the unit, see Point 7.4
Note
High air pressure is always associated with n weather, while
low air pressure indicates wet weather.
7.11 Temperature indicator
• Brie y press the Up button (B) to switch between Celsius and
Fahrenheit.
7.12 Frost alarm
• If the outdoor temperature is between -1°C and 3°C, the frost
symbol (8) ashes on the display.
7.13 Alarm clock
Setting the alarm
• Press the alarm clock button (F) for around 3 seconds and the
hour of the alarm time starts to ash.
• Press the Up button (B) or Down button (C) to select the hour
of the alarm time and con rm the selection by pressing the
Alarm clock button (F).
• The minute display starts to ash. Repeat the procedure for the
minutes of the alarm time.
• Con rm the selection by pressing the Alarm clock button (F).
Deactivating / activating the alarm
Brie y press the Alarm clock button (A) to activate the alarm.
An active alarm clock is shown in the display with the alarm clock
9