Hama KO SAMUI Bedienungsanleitung Seite 6

Warning - Batteries
• When inserting batteries, note the correct polarity (+ and -
markings) and insert the batteries accordingly. Failure to do
so could result in the batteries leaking or exploding.
• Only use batteries that match the speci ed type. Keep the
instructions for the correct choice of batteries included with
the operating instructions of devices safe for future reference.
• Before you insert the batteries, clean the battery contacts
and the polarity contacts.
• Do not allow children to change batteries without
supervision.
• Replace all the batteries in a set at the same time.
• Do not mix old and new batteries, or batteries of different
types or from different manufacturers.
• Do not short-circuit batteries.
• Do not charge batteries.
• Do not burn batteries or heat them up.
• Never open, damage or swallow batteries or allow
them to enter the environment. They can contain toxic,
environmentally harmful heavy metals.
• Remove spent batteries from the product and dispose of
them without delay.
• Avoid storing, charging and using in extreme temperatures
and at extremely low atmospheric pressures (such as at
high altitudes).
• Ensure that batteries with damaged housings do not come
into contact with water.
• Keep batteries out of the reach of children.
5. Setup
5.1 Inserting the batteries
Measuring and base station
• Remove the protective lm from the display.
• Open the battery compartment on the back of the measuring
station and insert 2 AAA batteries, observing the correct
polarity.
• Open the battery compartment on the back and insert 3 AAA
batteries, observing the correct polarity.
• Then close the battery compartment cover.
Note
• Please remember, during commissioning, to always insert the
batteries into the measuring station rst.
6
5.2 Changing batteries
Measuring station
• If the battery warning symbol (25) appears, replace the batteries
in the measuring station with two new batteries.
• Open the battery compartment, remove and dispose of the
spent batteries and insert two new AAA batteries observing the
correct polarity. Then close the battery compartment cover.
Base station
• If the battery warning symbol (18) appears, replace the batteries
in the base station with three new batteries.
• Open the battery compartment (28), remove and dispose of the
spent batteries and insert three new AAA batteries, observing
the correct polarity. Then close the battery compartment cover.
6. Installation
Note - Installation
• We recommend initially positioning the base station and
measuring station at the preferred setup locations without
installing them and carrying out all the settings - as
described in 6. Operation.
• Do not install the station(s) until the settings are correct and
the radio connection is stable
Note
• The range of the radio transmission between the measuring
station and the base station is up to 30 m in unobstructed
areas.
• Before installing, make sure that the radio transmission is
not in uenced by interfering signals or obstacles such as
buildings, trees, vehicles, high-voltage power lines, etc.
• Before nal installation, make sure that there is su cient
reception between the desired installation locations.
• When installing the measuring station, take care to ensure
this is positioned so that it is protected from direct sunlight
and rain.
• The international standard height for measuring air
temperature is 1.25 m (4 ft) above ground.
Warning
• Buy special or suitable installation material from a specialist
dealer for wall-mounting.
• Ensure that you do not install any faulty or damaged parts.
• Never apply force during assembly. These can damage the
product.
• Before mounting, check that the wall you have chosen is
suitable for the weight to be mounted. Also make sure
that there are no electric, water, gas or other lines running
through the wall at the mounting site.
• Do not mount the product above locations where persons
might sit or stand.