ECOVACS Winbot Mini Bedienungsanleitung Seite 11

3. Quick Start
Start
1
1.Connect the power supply and long press the WINBOT start button
for 2 seconds.
2.After hearing the fan start, place the bottom of the WINBOT (the
side with the mopping pad) on the glass. WINBOT will adhere to the
window automatically and start cleaning.
* Do not stick the WINBOT too close to the edge when cleaning the frameless
glass. It is recommended to be more than 10cm away from the edge.
* WINBOT can only clean flat surfaces. Please make sure that the glass
thickness is not less than 3mm.
* Do not put the fan close to hair and other small objects after power on, so as
not to block the fan.
* Before cleaning, please observe the area to attach WINBOT for any small
particles. If there are any, please remove them or switch to a particle-free area
to avoid scratching the glass.
* Please dry the water droplets at the spray outlet before cleaning.
EN 10
Maintenance during Cleaning
2
For heavily stained glass, please wash or replace the mopping pad
several times and clean the four spherical sensors in time.
* Clean in time when the mopping pad is dirty. Make sure that the small
particles on the mopping pad are completely removed to avoid scratching the
glass.