Werbung
Verfügbare Sprachen
Verfügbare Sprachen
O
O
HALL
BEDROOM
GARAGE
KITCHEN
BASEMENT
fil
How
to Install
This
Alarm
! IMPORTANT!
THIS COMBINATION
SMOKE/CO
ALARM
IS DESIGNED
! WARNING!
FAILURE
TO PROPERLY
INSTALL
AND
ACTIVATE
WILL
PREVENT
ITS RESPONSE
TO FIRE HAZARDS
Locations
to Avoid
WARNING- This product isintended for use in ordinary indoor ocations offamiy
measure compliance with the Occupational Safetyand Health Administration (OSHA)commercial or industria
standards.
l. Do not instal in garages, kitchens, furnace rooms or bathrooms! Do not insta within 5 ft or I .5 m of cooking
appllances.
MASTER
BEDROOM
FIRE
EXTINGUISHERS
SMOKE
ALARMS
FAMILY
ROOM
CARBON
MONOXIDE
ALARMS
SMOKE
& CO ALARMS
WORKSHOP
fil
TO BE MOUNTED
ON THE CEILING
OR WALL.
THIS ALARM
WILL
PREVENT
PROPER
OPERATION
OR CO.
'ving units. It is not designed to
•10
•
2. Do not instal within 3 ft (0.9 m) of the fol owing: The door to a kitchen, or a bathroom that contains a tub or shower,
forced air supp y ducts used for heating or cooling, ceiling or whole house ventilating fans, or other high air flow
areas.Avoid excessivey dusty, dirty or greasy areas.Dust, greaseor household chemicals can contaminate the alarm's
sensors, causing the a arm to not operate properly.
3. Place the alarm where drapes or other objects wi not block the sensors. Smoke and CO must be able to reach the
sensors to accurate y detect these conditions. Do not instal in peaks of vaulted ceilings, "A" frame ceilings or gabled
roofs. Keep out of damp and humid areas.
nstall at east one (1) foot away from fluorescent
4.
in direct sunlight and keep out of insect-infested areas. Extreme temperatures will affect the sensitivity of the
smoke/CO a arm. Do not instal in areas where the temperature
(37.800, such asgarages and unfinished attics. Do not instal in areaswhere the relative humidity (RH)isabove 85%
Placeaway from doors and windows that open to the outside.
5. Smoke alarms are not to be used with detector guards unless the combination
and found suitable for that purpose.
Mounting
1. Dril three Ø 6.0 mm holes in the wal or ceiling, then insert three plastic anchor plugs into the holes with a hammer.
2. Attach the mounting
bracket by pushing them together and twisting the unit clockwise.
3. Test the unit by using the Test/Si ence button. Ensure the unit sounds in an alarm pattern.
Note: This model is equipped
the mounting
OF THE ALARM
AND
ights, as electronic noise may cause nuisance a arms. Do not place
Steps
bracket to the surface of the wall or ceiling with three screws and mount the alarm into the
with a feature
that automatically
bracket for the first time.
•11
•
is colder than 40 OF(4.4 'C) or hotter than 100 OF
(alarm and guard) has been eva uated
activates the alarm when the alarm is attached to
Werbung
