x-sense SC03 Bedienungsanleitung Seite 4

contact the manufacturer directly, for more information about CO safety and this equipment. Make sure that motor vehicles are
not, and have not been, operating in an attached garage or adjacent to the residence.
Package Contents
1 x Alarm Unit
1 x Mounting Bracket
3 x Screws
3 x Anchor Plugs
1 x User Manual
1 x Warranty Card
Technical Specifications
Power supply
Sensor type
Product life
Safety standards
CO sensitivity
Standby current
Alarm current
Best operating ambient temperature range
Operating re ative humidity range
Alarm oudness
Silence duration
I O-year sea ed lithium battery
Smoke: Photoelectric
CO: Electrochemica
About 10 years
EN 146042005 & EN 5029
50 pprn: 60 90 minutes
100 ppm: 10-40 minutes
300 ppm: < 3 minutes
< 6 PIA(avg.)
< 60 mA (avg.)
40 100 OF(4.4 37.8 OC)
85% RH (nan-condensing)
> 85 dB at 9.84 ft (3 m) @3.2 ± 0.3 kHz pulsing alarm
s 9 minutes
• 04 •
Product Overview
! CAUTION!
THIS SMOKE AND CO ALARM IS DESIGNED FOR INDOOR
OR DROP THE ALARM. DO NOT OPEN OR TAMPER WITH THE ALARM
Test & Silence Button
The Test & Silence button is used to test the unit's electronics and to si ence the unit during an alarm. When testing
the a arm weekly, press the test button until you hear a short beep, indicating that the alarm hasentered the test
mode.
Note: After a test has begun, the alarm will sound and the red LED will flash. This does not indicate
smoke/CO is present.
f you press the test button during an alarm state, the unit wil enter the si ence mode.
CO silence mode: pressthe test button during an alarm state, the unit wil enter the sience mode. If the CO density
stil exceeds the a arm threshold within 6 minutes,
from silence mode after 9 minutes.
Note: If the smoke or CO concentration has reached an alarm level, after the silence time has expired, this unit
will continue to alarm until the smoke or CO concentration
Alarm Sounder
The alarm will sound when there is smoke or CO present, when testing the alarm, and when there isa fault.
LED Indicator
The LED indicator wil flash in conjunction with the alarm sounder. Therefore, it wil flash during the fol owing states:
when powering on, in standby mode, during smoke or CO a arm states, when exiting an alarm state, during test mode,
when there is ow battery, in si ence mode, when there is a fau t and when the unit is at the end of its life.
Low Battery
The LED indicator wil flash yel ow together with one beep every 60 seconds.
THE UNIT MUST BE DEACTIVATED (see "Deactivation
POSSIBLE.
(If you press the test button when there is ow battery, the ow battery signal will temporarily cease for 10 hours; if you
press the test button again, the unit wil enter the test mode and then the standby mode.)
USE ONLY. DO NOT EXPOSE TO RAIN OR MOISTURE.
AS THIS COULD CAUSE MALFUNCTION.
the unit wi enter another alarm state. Otherwise,
decreases to a safe, low level.
of the Alarm" section) AND REPLACED AS SOON AS
DO NOT KNOCK
that
the unit wil exit