EGO Pro X HTX6500 Bedienungsanleitung Seite 7

WARNING:
Do not use any attachments or
accessories not recommended by EGO
attachments or accessories not recommended can result in
serious personal injury.
Before each use, inspect the entire product for damaged,
missing, or loose parts, such as screws, nuts, bolts, caps, etc.
Tighten securely all fasteners and caps and do not operate
this product until all missing or damaged parts are replaced.
The product may be used in rain.
INSTALLING/REMOVING THE BATTERY PACK
Use only with the battery packs and chargers
listed in Fig.A
Charge before first use
To Install (Fig. B & C & D)
With aligned ▲ logo respectively on the plug and the hedge
trimmer, insert the plug into the hedge trimmer until the green
seal completely disappearing into the socket.
Mount the battery cord into the "U" hook.
To Remove (Fig. E)
Release the battery cord from the "U" hook and pull the
plug out of the hedge trimmer.
STARTING/STOPPING THE HEDGE TRIMMER
Before operating, remove the shield and hold the trimmer
with both hands, one hand on the rear handle and the
other on the front handle. Then check for balanced
footing, correct posture and a proper cutting distance.
WARNING:
Always keep both hands on the hedge
trimmer handles. Never hold shrubs with one hand and
operate the hedge trimmer with the other. Failure to heed
this warning may result in serious injury.
WARNING:
When stopping the hedge trimmer,
switch the lock-off button to passion "OFF" before remove
the battery pack. Failure to follow this warning may cause
serious injury.
To Start
Push the lock-off button to position "ON" (Fig. F) and then
press the rear switch level. With rear switch level pressed,
continue pressing the front switch lever to start.
Fig. F parts description see below:
F-1 Lock-off Button
F-2 Rear Switch Lever
56 VOLT LITHIUM-ION CORDLESS HEDGE TRIMMER — HTX6500/HTX7500
To Stop
. The use of Release either of the switch levers to stop it and switch
TM
the lock-off button to position "OFF" to prevent accidental
start.
NOTICE:
hedge trimmer to start.
HOLDING THE HEDGE TRIMMER
With the blade away from you, hold the trimmer with two
hands, separately grasping the front and the rear handle.
Three holding directions can suit for different cutting
operations (Fig. G & H & I).
USING THE HEDGE TRIMMER
WARNING:
or line, DO NOT TOUTCH THE BLADE! IT CAN BECOME
ELECTRICALLY LIVE AND VERY DANGEROUS. Continue
to hold the hedge trimmer by the insulated rear handle
or lay it down and away from you in a safe manner.
Disconnect the electrical service to the damaged line or
cord before attempting to free the blade from the line or
cord. Failure to heed this warning will result in serious
personal injury or possible death.
WARNING:
hands away from blades. Do not attempt to remove cut
material or hold material to be cut when the blades are
moving. Make sure that the blades have totally stopped
and the battery pack is removed before clearing jammed
material from blades. Do not grasp the exposed cutting
blades or cutting edges when picking up or holding the
unit.
WARNING:
Remove all objects, such as cords, lights, wire, or string
which can become entangled in the cutting blade and
create a risk of serious personal injury.
WARNING:
through the heavy shrubbery. This can cause the blades to
bind and slow, reducing the cutting efficiency.
NOTICE:
for the stems fed directly into the cutting blade. For older
growth, a sawing movement is good for trimming the
thicker stems. A non-powered hand saw or pruning saw is
suggested for trimming the large stems first.
Top Cutting
Use a wide sweeping motion. A slight downward tilt of the
cutting blades in the direction of motion gives the best
cutting results. For better cutting effect, you might as well
Both switch levers need to be pressed for the
If the blade jams on any electrical cord
To prevent serious personal injury, keep
Clear the area to be cut before each use.
Avoid trimming too much at one time or
For new growth, a wide sweeping is suitable
EN
7