How To Install The Indoor Unit; Ceiling Type (T2 Type); Required Minimum Space For Installation And Service - Panasonic S-50PT2E5 Installationsanleitung

3. HOW TO INSTALL THE INDOOR UNIT

■ Ceiling Type (T2 Type)

3-1. Required Minimum Space for Installation and
Service
(1) Dimensions of suspension bolt pitch and unit
Length
A
Type
36, 45, 50 911
60, 71 1226
100, 125, 140 1541
(2) Refrigerant tubing • drain hose position
Left side
267
Left drain position
Closed with rubber stopper
at time of shipment.
(3) Unit opening position (Refrigerant tubing • drain hose • power inlet port • remote control wiring inlet port)
Left-side drain hose
outlet port
*1
*1
Outside air intake duct
connection port
120
(ø100, cutout)
Left-rear side drain
90
hose outlet port
(cutout)
B C
960 235
1275 235
1590 235
Unit: mm
Rear (Figure shows view from front)
Gas tubing
Liquid tubing
90
Left drain position Right drain position
Top outlet port
Rear outlet port (Figure shows view from front)
Remote control wiring
and inter-unit wiring inlet port
123 61
Cover of tubing hole
Power inlet port
25
(Suspension bolt pitch)
70 86
90
Right drain position
88
*2
Side cover
123
*1 Use a compass saw, jig saw or similar tool and cut along
the indented portion of the side cover and make a hole
inside the cover.
*2 When removing the refrigerant tubing from the upper
side, cut along the indented portion and pass the tubing
through the hole.
NOTE
Be sure to use sealing putty to seal off the opening to
prevent dust.
7
B
C
A
25
Right side
216
(Liquid tubing •
Gas tubing)
187
267
Right-side drain
hose outlet port
*1
*1
Unit: mm
Air intake
Air
Fig. 3-1
Unit: mm
Fig. 3-2
Unit: mm
Fig. 3-3