Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4
78
Release the flow button
-
if the value is above or below the specified gas flow rate, check the welding torch
for damage
-
if necessary, repair the welding torch
-
repeat the gas flow test after the torch has been repaired
NOTE! For the specified gas flow rates, refer to the "Welding torch flow rates"
service test schedule (PP-SER-2001). The "Welding torch flow rates" service test
schedule (PP-SER-2001) is available from the DownloadCenter.
Screw the welding torch connection (1)
1
onto the 3/8 TIG / PLASMA attachment
on the adapter (2)
Press and hold the flow button on the
2
adapter (2)
-
The gas flow rate is measured
(1)
Note the value shown on the testbox
3
(2)
display and compare with the specified
gas flow rate
Werbung
