SETTINGS _____________________________
Set the Clock
1. In Standby mode, press and hold CLOCK
button to entering clock setup.
2. Press the
/
buttons on the remote control
to select options, and then press the OK but-
ton to confirm.
12/24
Set 12 hour or Set 24 hour display.
hour
0 : 00
Here you can manually set the time (hour
and minute).
SYNC
Set synchronization the Clock:
• OFF: No Synchronization
• ANY: Synchronization from Any
• FM: Synchronization from FM
• DAB: Synchronization from DAB
Note:
• Each activated state will be cleared if any but-
tons are not pressed within 15 seconds.
Time Display
• Press the CLOCK button to show the current
time on the display for a few seconds.
Set the alarm Timer
• The clock must be correctly set for the timer to
operate correctly.
1. In Standby mode, press and hold ALARM
button to entering alarm setup.
2. Press the
/
buttons on the remote control
to select options, and then press the OK but-
ton to confirm.
7 : 00
Here you can manually set the alarm
time (hour and minute).
Source
BUZZER / FM / DISC / USB / DAB
• BUZZER (to wake to a buzzer sound)
• DAB (to wake your selected DAB Ra-
dio Station
• USB (to wake to your USB music)
• FM (to wake your selected FM Radio
Station)
• DISC (to wake to your CD music)
• (If the wake-up source is DAB / FM
and the signal strength is low, the
Buzzer alarm will be triggered.)
Volume
Adjust the alarm volume
Alarm On/
Select to Alarm On / Alarm Off
OFF
• ON :
• OFF: icon disappear
Activate and Deactivate the
Alarm Timer
• After setting the alarm timer, press the ALARM
button on the remote control to view the alarm
settings.
• The alarm is active when
display.
• To deactivate the alarm, press the ALARM but-
ton twice. The
will disappear on the display.
Press the ALARM button twice again to acti-
vate the alarm timer.
• When the alarm rings, press the SNOOZE
button on remote control. The alarm repeats
ringing 9 minutes later.
• When the alarm rings, press
off the alarm.
Tips:
• Each enabled state will be cleared if a button
is not pressed within 15 seconds.
• When the alarm rings, press the
the remote control or on the unit. The alarm
stops but the alarm settings remain.
icon display
is shown on the
button to turn
button on
ENGLISH
45