Powerplus POWAIR0312 Bedienungsanleitung Seite 41

Tool does not operate
well: can not drive
fastener or operate
sluggishly.
Tool skips fasteners.
Tool jams.
Copyright © 2024 VARO
POWAIR0312
Inadequate air supply.
Inadequate lubrication.
Worn or damaged O-rings
or seals.
Exhaust port in cylinder
head is blocked.
Worn bumper or damaged
spring.
Dirt in front plate.
Dirt or damage prevents
fasteners from moving
freely in magazine.
Worn or dry O-ring on
piston or lack of
Lubrication.
Cylinder covers seal
leaking.
Incorrect or damaged
fasteners.
Damaged or worn driver
guide.
Magazine or nose screw
loose.
Magazine is dirty.
P a g e
Verify adequate air supply.
Place 2 or 6 drops of oil
into air inlet.
Check and replace O-rings
or seal.
Replace damaged internal
parts.
Replace bumper or pusher
spring.
Clean drive channel on
front plate.
Magazine needs to be
cleaned.
O-ring needs to be
replaced and lubricate.
Replace Sealing washer.
Change and use correct
fastener.
Check and replace the
driver.
Tighten the magazine.
Clean the magazine.
| 10
EN
www.varo.com