Service; Special Safety Instructions For Electric Staplers; Safety Rules (Fig. B) - Powerplus Powair0312 Bedienungsanleitung

▪
Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp
cutting edges are less likely to jam and are easier to control.
▪
Use the power tool, accessories and cutting tools, etc., in accordance with these
instructions and in the manner intended for the particular type of power tool, taking
into account the working conditions and the work which needs to be done. Using a
power tool in ways for which it was not intended can lead to potentially hazardous
situations.
5.5

Service

▪
Your power tool should be serviced by a qualified specialist using only standard
spare parts. This will ensure that it meets the required safety standards.
6

SPECIAL SAFETY INSTRUCTIONS FOR ELECTRIC STAPLERS

▪
Before inserting staples or nails the power plug should always be removed from the
socket.
▪
Never point the machine at persons or animals.
▪
Only use staples or nails which are suitable for the machine.
▪
Before using the machine, ensure that the safety device is operating properly.
▪
Never block the safety device.
▪
Switch the machine off when you take a break and when the work is completed.
▪
Wear ear protectors.
▪
Do not activate the tool unless the tool is placed firmly against the workpiece. If the
tool is not in contact with the workpiece, the fastener may be deflected away from
your target.
▪
Do not use the tacker for fastening electrical cables. It is not designed for electric
cable installation and may damage the insulation of electric cables thereby causing
electric shock or fire hazard.
7

SAFETY RULES (FIG. B)

▪ Use only following fixing devices:
− Ga. 18 nail & staple
− Nails length: 15-50mm
− Staple crown: 5.7mm
− Staple length: 16-40mm
▪ Tools with an inverted triangle can only be used with security elements: this
stapler/nailer is equipped with a safety yoke.
▪ To prevent injuries to yourself and bystanders, refer to tool use, maintenance and
troubleshooting sections for additional information (fig 1)
▪ To prevent eye injuries, always wear safety glasses with hard plastic side shields. Be
sure everyone in your work area is wearing the same type of safety glasses (fig 2)
▪ Always wear hearing protection and hard hat. (fig 3)
▪ Never use hydrogen oxygen, carbon dioxide or any other bottled gas as a power
source for this tool, the tool will explode and cause serious injury. (fig4)
▪ Remove finger from trigger when not driving fasteners. Never carry tool with finger on
trigger, tool will eject fastener If safety is bumped. (fig5)
▪ Never conned tool to an air hose with pressure exceeds 200 psi or 13.7 BAR (fig6)
▪ Air compressors must comply with requirement ANSI B19.3 1981 (U.S.), "Safety
Standard For Compressors For Process Industries." (fig 7)
Copyright © 2024 VARO
POWAIR0312
P a g e | 5
EN
www.varo.com