Depth Adjustment (Fig. 1); Maintenance - Powerplus Powair0312 Bedienungsanleitung

▪ Use the proper lubricant in the air line lubricator. The lubricator should be of low air flow
or changing air flow type, and should be kept filled to the correct level. Use only
recommended lubricants, specially made for pneumatic applications. Substitutes may
harm the rubber compounds in the tools, O-rings and other rubber parts.
9.1

Depth adjustment (fig. 1)

The depth to which a fastener is driven is controlled by the depth adjustment knob (8). The
depth of drive is factory adjusted to a nominal setting. Test fire a fastener and check depth.
If a change is desired, rotate the adjustment knob (8). Rotate the knob (8) clockwise to
increase the depth of drive, rotate the knob counter clockwise to decrease the depth of drive.
Test fire another fastener and check depth again. Repeat as necessary to achieve desired
results. The amount of air pressure required will vary depending on the size of the setting to
determine the lowest setting that will consistently perform the job at hand. Air pressure in
excess of that required can cause premature wear and/or damage to the tool.
IMPORTANT!
If no filter/ pressure regulator/ lubricator is installed in the compressed air system, then
pneumatic tools must be lubricated with 2 to 6 drops of oil at least once a day or after every
two hours of use. This must be done directly along the male coupler or the screw (OIL)
provided for the purpose on the side of the tool's housing.
Fig. 2
1. Tool
1. Quick connector
2. Quick coupler
3. Air hose
4. Quick connector
5. Quick coupler
10

MAINTENANCE

Disconnect the tool from the compressor before adjusting, clearing jams,
servicing &maintenance, relocating and during non operation.
▪ Regular lubrication, if your tool without using the in-liner automatic oilier, place 2 or 6
drops of pneumatic tool oil into the air inlet before each work day or after 2 hours of
continuous use depending in the characteristic of work piece or type of fasteners.
▪ Air-operated tools must be inspected periodically, and worn or broken parts must be
replaced to keep the tool operating safely and efficiently. Check and change all worn or
damaged O-ring, Seals, etc. Tight all the screws and caps in case personal injury.
▪ Make regular inspection for free movement of trigger, Spring and safety mechanism to
assure safe system is complete and functional: no loose and missing parts, no building
or stocking parts.
▪ Keep magazine and nose of tool clean and free of any dirt lint or abrasive particles.
▪ When temperatures are below freezing, tools should be kept warm by any convenient,
safe method.
Copyright © 2024 VARO
POWAIR0312
6.
7.
8.
9.
10.
P a g e | 8
Lubricator
Regulator (0-8.3 bar)
Filter
Cut-off valve
Air compressor
www.varo.com
EN