Electrical Connection/Control Elements Pa 1-R / Pa L 1-R; Connecting The Operating Voltage - Pfannenberg Pa 1-R Betriebsanleitung

en
6.2

Electrical connection/control elements PA 1-R / PA L 1-R

The electrical connection is made on the board in the top section/in the lens.
S2
Operating modes of
the signal lamp
Control inputs/
operating voltage (only C2)
Operating voltage connection
6.3

Connecting the operating voltage

Signal lamp and sounder can be supplied together or separately in the PA L 1-R combi-device.
Set the DIP switch S2 on the board as follows:
PA 1-R:
Connection of the operating voltage
PA L 1-R: Common supply of signal lamp
and sounder
PA L 1-R:
Separate supply of signal lamp and
sounder
10/2024
S1
Tone settings
Further information in the
QuickGuide
Operating Manual PA 1-R / PA L 1-R
Page 6 / 12
The connecting wires are
inserted into the open-
ings provided by the
push-in principle.
S2
S2: all switches to OFF
Factory setting*
S2
S2: Switch 8 to ON
086200019c