Commissioning; Safety Information; Lens Cap - Pfannenberg Pa 1-R Betriebsanleitung

en

6. Commissioning

6.1

Safety information

DANGER - Danger to life due to electric shock
Voltage-carrying units and exposed connection cables may cause electric shocks and serious
accidents.
 Only trained and authorized electricians may work on electrical connections.
 Disconnect all supply lines from mains before installation and secure them against reconnec-
tion. Always ensure absence of voltage.
 Wait for the discharge phase of 5 minutes for the electrical components. The unit should only
be opened afterwards.
 The operating voltage must only be applied when the housing is firmly closed.
WARNING - Danger due to unauthorized use of the devices
Improper use may lead to serious accidents.
 Ensure that the connection cable is protected against pulling and twisting during installation.
 The devices are only intended for fixed assembly.
DANGER - Danger due to damage to the devices
Non-compliance with the information on the type plate can lead to serious accidents.
 Always observe the information on the type plate when installing and maintaining the units.
CAUTION - Risk of injury due to sharp edges or heated components
 Wear suitable personal protective equipment (PPE) for installation, assembly or ser-
vice/maintenance work.
 Keep wiring away from sharp edges, corners and internal components; avoid collisions with
component parts.
CAUTION - Risk of sight impairment
 Avoid constant, direct glances into the activated lights to prevent impairment of vision.
 Unexpected triggering of the flash can lead to startled reactions.
CAUTION - Risk of hearing impairment
 Wear sound insulation equipment during work/testing to prevent hearing impairment.
 Unexpected triggering of the sound can lead to startled reactions.
6.1

Lens cap

Opening the lens
Insert a screwdriver (3 mm blade width) in the
marked opening and lever out the lid by turning 90°.
The device is delivered in an unsealed condition.
10/2024
Operating Manual PA 1-R / PA L 1-R
Closing the lens
Place the lens on the housing (pay attention to anti-
twist protection) and close with slight pressure.
Page 4 / 12 086200019c