Troubleshooting - Renkforce Moon-Fog Bedienungsanleitung

13. Troubleshooting

By purchasing this device, you have acquired a product designed to the state of the art and operationally reliable. Nev-
ertheless, problems or errors may occur. Therefore, we would like to describe how to eliminate possible errors here:
Always observe the safety information!
No function after the device has been switched on
• The mains plug is not plugged into the socket correctly.
• The low-voltage plug is not correctly connected to the device mains connection (4).
• The mains socket is not supplied with current.
• The fuse triggered. Replace it (see "Fuse Replacement"). Should the fuse trigger again, have the device repaired
in a specialised workshop.
There suddenly is no fog in operation anymore
• The device performs subsequent heating. Once the reheating process is complete, the device will emit fog again.
• The device no longer is connected to the voltage supply. Check for correct connection and voltage supply to the
mains socket.
• The tank is empty. Let the device cool off and top up the tank again.
The device produces fog for a short time after deactivation/disconnection
• It is not a defect. The remaining fog liquid in the still-hot fog exit opening evaporates.
The sound-to-light control of the light effect does not work
• Music playback volume is too low. Try setting a higher volume or increasing the microphone sensitivity.
• Test the function of the installed microphone by tapping a finger on the housing. The sound-to-light control should
react to these impulses.
Repairs other than those described above must only be carried out by an authorised specialist.
27