x-sense CO03D Bedienungsanleitung Seite 3

Important Note
This user manual contains important information regarding the installation and operation of your
carbon monoxide alarm. Pleasetake a few minutes to thoroughly read this manual which should
be saved for future reference. f you are installing the carbon monoxide a arm for use by others, you
must leavethis manual or a copy of it
Introduction
This device is a battery powered stand alone CO (carbon monoxide) a arm with an advanced
electrochemical sensor for domestic use.Please note that this device does not detect smoke, heat,
flames or any hazardous gas other than carbon monoxide even though carbon monoxide can be
generated by fire. For this reason you must install smoke a arms to provide early warning of fire and
to protect you and your fami y from fire and its related hazards.
Warning!
The installation of the apparatus should not be used as a substitute for proper installation, use and
maintenance of fuel-burning appliances including appropriate ventilation and exhaust systems.
This apparatus is to be installed by a competent person.
It is not tested for use in a caravan
Product Profile
LCDdisplay
Fault indicator/yel ow LED
Buzzer
02
with the end user.
or boat.
X•scNse
04
Alarm indicator/red LED
Power indicator/ reen LED
TEST/HUSH button
Package Contents
1 XCO alarm 3 x 15V batteries 2 x Screvvs
Product Features
Low battery warning
f the battery voltage is ow, the unit will chirp once every 60 seconds to indicate the need for
battery replacement.
End-of-life indication
MPORTANT: T en (10) years after it is first powered, the alarm will chirp 2 times every 30 seconds
to indicate that it is time to rep ace the a arm.
End-of-life hush control
This model has an end of-life hush feature, which disables the "chirps" for a period of 3 days by
pressing the "TEST/HUSH"button. You can replace your alarm within this time at your convenience.
The chirp sound will be issued again every 3 days and can be hushed again for a total period of 30
days until a replacement is final y required.
During this end-of-life hush period, your alarm continues monitoring CO and provides protection as
usual.
To help identify the date to replace the a arm, write down the date of first operation on the
dedicated label on the side of the alarm.
2 x Anchor plugs I x User manual I x Warranty card
03