SoundLight DMX RDM Bedienungsanleitung Seite 34

PID C010 MID POINT OFFSET
This function sets the position offset for the center point sensor. Usually, a inductive sensor is
being used, which is detected over a certain span when the nozzle is moving.
The zero point detector is flank triggered only when the nozzle is moving upward. To compensate
for the detection range, a MID POINT OFFSET value can be defined using this function. The data
entry range is 000...255 (00
tory. Normally, this will work out fine for all standard applications.
...FF ), with the default set to center position 128 (80
hex hex
Calls: GET <param = none> (no parameter needed)
Return: <param=MidPointOffset [1 Byte]>
SET <param=MidPointOffset [1 Byte]>
Return: <param=none> (no parameter returned)
) at the fac-
hex