Eingangspolarität Ändern - Soundlight Dmx Rdm Bedienungsanleitung

PID 8438 INPUT POLARITY
This function sets the polarity of the switch sensor inputs.
Calls: GET <param = none> (no parameter needed)
Return:
SET <param=Polarity [1Byte]>
Return:
Polarity = $FF
Polarity = $00
From firmware version 1.1 onward, single switches can be inverted individually. Where available,
use personality 3 „Test Mode" to check for functionality and proper setting of the switch inputs.
Switches should be set to show „L" when disengaged (operational mode) and „H" when engaged
(error mode).
Changing the polarity of the center switch will result in changing the center point trigger flank.
RIGHT SWITCH:
CENTER SWITCH: Bit 1
LEFT SWITCH:
Normal Mode:
Inverted Mode:
Example: to invert the right and the left end sensor switch input, add 1+4 = 5.
Thus Polarity = $05
<param=Polarity [1 Byte]>
<param=none> (no parameter returned)
all normal polarity (standard mode)
all inverted polarity
Bit 0 (normal: add value 1, inverted: add value 0)
(normal: add value 2, inverted: add value 0)
Bit 2 (normal: add value 4, inverted: add value 0)
Bit set
Bit not set
EINGANGSPOLARITÄT ÄNDERN