Flashforge Adventurer 5M Benutzerhandbuch Seite 8

Insert the filament guide tube to the extruder and insert the other end of the filament
guide tube into the filament detection sensor.
Installing the Screen
Note: Before the installation, please remove the tape of the screen cable. Tear it off
gently to avoid damaging the cable.
As shown in the picture, insert the screen cable into the screen connector.
Lift the buckle on the screen's cable socket to the indicated position (Fig. 1), then insert
the screen cable into the socket connector. Note: Ensure proper insertion and check
alignment of the indicator line with socket. Press down the buckle on the cable socket to
the indicated position according to the arrow direction (Fig. 2).
8