Flashforge Adventurer 5M Benutzerhandbuch Seite 7

Initial Setup
Unboxing
Safety notice: Do not power on the printer until the installation is completed.
First, open the box. Remove the upper foam packaging, Quick Start Guide and After-
sales Service Card. Take out the machine, place it on a level workspace and remove the
packaging bags and tapes. Remove the filament, power cable, screen, and accessory box
from the chamber protective foam. Remove the inner protective foam from the
extruder. Move the chamber foam according to the arrow direction and remove the
foam.
Packing List
3D printer
•
Filament
•
Power cable
•
After-sales service card
•
Quick start guide
•
Touch screen
•
Spool holder (with 2 screws)
•
Grease
•
Glue
•
Diagonal pliers
•
Unclogging pin tool
•
Screwdriver
•
Allen wrench (2.0, 2.5, 3.0)
•
Installing the Spool Holder and Filament Guide Tube
Take out the two screws and spool holder from the accessory box. Install the spool
holder at the position shown in the figure with the two screws. (Note: Please tighten
them using a 2.0mm Allen wrench.)
7