SPERONI PM 20 Bedienungsanleitung Seite 13

1. Safety Measures
• Read carefully the operating
The appliance must not be used by operators who are not thoroughly acquainted
with the instructions handbook (operating instructions). Moreover, the appliance
must not be used by persons under the age of 16.
• The user is liable towards
operation
• Before starting
electrical protection
While the pump
be pumped.
The pump may be connected
currents, with a rated opening
earth contact
least 10 Amps.
Operation in swimming
For other operation, the provisions
part 702 must be respected.
CAUTION: Before checking,
voltage!
Replacing the connecting
this must carried out by the manufacturer
The pump may only operate with a pipe connecting
that is no lighter than a rubber hose mod. H07 RNF in compliance
DIN 57282 or DIN
• The noise (continuous
less or equal (s) to 70 dbA.
• The voltage (230 Volts alternating current) indicated on the pump' s rating
plate must correspond
• The temperature
• Make sure that the plugged
flooding and are protected
• Before use it is necessary to check that the plug and the mains connection
are not damaged.
• Unplug from the mains before performing
• Avoid directly exposing the pump to the jet of water.
• The user is responsible
and safety.
• The user by taking appropriate measures (e.g. installing an alarm, reserve pump
and the like) will have to exclude the possibility
flooding premises due to failure of the pump.
instruction
third parties in the area where the appliance
it is necessary
measures, by means of a test carried out by a specialist.
is operating
installed in compliance
pools and garden ponds is not recommended.
connect
up line requires using special tools and therefore
57245 standard.
equivalent
to the available mains voltage.
of the liquid conveyed
electrical
from humidity.
for complying
before assembling
to make sure that there are the necessary
persons must not be in the liquid
only by means of a safety
current up to 30 mA and a socket
with the regulations.
in conformity
the pump and the system
or its service engineers.
in dbA) of the motor-driven
must not exceed 400C
connections
any work on the pump.
with the local regulations
12
and starting.
switch
Protection:
with the standard VDE 0100
the appliance
are in an area safe from
of indirect damage caused by
is in
to
for fault
with an
at
with no
(extension)
with the
pump is
line
for assembly