Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
-
To solve this, before starting the coffee machine, it is recommended to prime or bleed the
pump manually by injecting water into the internal pipes with the help of a tube.
-
Carry out the following steps:
1.
Remove the water tank and insert the tube into the inlet at the bottom of the tank to
connect it to the pump. Fig. 5
2.
Inject a small amount of water into the tube. Fig. 6.
Push the valve down to allow water to enter the appliance and completely expel the air
3.
from the pump lines through the pipe. Fig. 7
Once this procedure has been carried out, the coffee machine will be able to pump water
4.
normally.
NOTE: repeat this process 2 or 3 times if necessary.
Adjusting the amount of coffee dispensed
The amount of coffee dispensed by the appliance can be changed by adjusting the preset
1.
brewing time.
To do so, press
2.
NOTE: the machine will save your selection.
On the adjustment has been made, press
3.
4.
The process can be cancelled at any time by pressing the button again.
Warning:
-
When pressing
process, which is normal.
-
To maximise the flavour of the coffee, it is recommended to brew a cup of hot water first.
Adapters
This coffee machine has three different adapters that allow you to enjoy three different types
of coffee:
-
Nespresso pods adapter. Fig. 8
-
Dolce Gusto pods adapter. Fig. 9
-
Ground coffee adapter. Fig. 10
Nespresso pods adapter
1.
Removing the adapter. Fig. 11
-
Lift the lever
-
Remove the adapter
2. Placing the pod in the adapter. Fig. 12
-
Open the adapter lid
40
FREESTYLE COMPACT
, according to your preferences.
, the button may flash for a few seconds before starting the extraction
to start the extraction.
Werbung
