Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3. OPERATION
Before use
Before using the coffee machine for the first time or when using it again after a long period of
inactivity (e.g. after a holiday), it is recommended to rinse it. This process allows the internal
ducts of the coffee machine to be thoroughly cleaned.
There are two ways to fill the water tank: either directly into the machine using, for example, a
jug, or by removing the water tank.
1.
Filling the tank without removing it. Fig. 2
-
Remove the water tank cover.
-
Use a jug to fill the tank with fresh water (maximum water temperature must not exceed
35 ℃).
-
The maximum tank capacity is 0.6 l.
-
Put the tank cover back in place.
2. Filling the tank by removing it. Fig. 3
-
To remove the water tank from the coffee machine, press it down slightly and pull it out.
-
Fill the tank with fresh tap water up to but not exceeding the "MAX" mark (maximum tank
capacity is 0.6 litres).
-
Put the water tank back in place and make sure that the tabs match the slots on the
appliance. Finally, press the tank down gently until it clicks into the base.
3. Connect the coffee machine to the power socket
4. Press the power icon to switch on the appliance
-
The icons on the control panel will flash slowly to indicate that the machine is preheating.
-
This process will take between 20 and 45 seconds and, once completed, all icons will
remain fix.
5. Dispensing coffee. Fig. 4
-
Then, place a cup under the coffee spout.
-
Press the coffee size icon to select the desired amount of coffee to be dispensed, then
press the coffee brewing icon to start the appliance.
-
Once the coffee is ready, lift the lever and remove the adapter. Discard the used pod.
-
Wash the adapter thoroughly.
Pump purging
-
Before using the coffee machine for the first time or when using it again after a long period
of inactivity (e.g. after a holiday), the machine may have difficulty pumping water.
ENGLISH
FREESTYLE COMPACT
39
Werbung
