Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Gas burners
The burners differ in size and power. Choose the most
appropriate one for the diameter of the cookware being
used.
The burner can be regulated with the corresponding
control knob "M" by using one of the following settings:
Off
High flame
Low flame
The symbols
near the knobs show the position of
the relative burner on the hob.
The burners are fitted with automatic ignition and
thermocouple safety device, which automatically cuts off
the gas from the burner in a few seconds if the flame
accidentally goes out during operation.
To ignite a burner, proceed as follows:
• turn the relative knob counter-clockwise until the pointer
is on the high-flame symbol;
• press the knob down fully to activate the automatic gas
ignition
;
• keep the knob pressed down for about 10 seconds with
the flame lit to allow the safety thermocouple to be
Using the burners
To obtain maximum efficiency from the burners, it is
advisable to use only pans with a diameter that is suitable
for the burner being used, so that the flame does not
extend beyond the pan base (see following table).
When a liquid starts boiling, it is advisable to turn the flame
down just enough to keep the liquid simmering.
B
u
n r
r e
R
a
p
d i
C (
)
S
e
i m
R -
a
p
d i
(
) B
A
u
l i x
a i
y r
(
) A
S
e
i m
F -
s i
h
b
u
n r
r e
D (
)
r T
p i
e l
R
n i
g
(
) T
The hob is fitted with a pan reducing support (fig.1),
which should only be used on the auxiliary burner "A".
Using the Half Fish-Kettle Burner
The two central burners, or Half Fish-Kettle burners, are
eliptic in form and can be turned up to 90°. This makes
the cooktop more flexible in terms of how it can be used.
To turn the two central burners 90°, proceed as follows:
•
Make sure that the burners are cool;
•
Lift the burner completely out of its housing.
How to use your appliance
Practical advice
ø
C
o
o
k
w
a
e r
d
a i
m
t e
r e
c (
m
2
2
–
2
4
1
6
–
2
0
1
0
–
1
4
1
6
-
2
0
2
4
-
2
6
fig.1
heated;
• release the knob, checking that the flame is stable. If it
is not, repeat the operation.
For minimum power, turn the knob towards the low flame
symbol. Intermediate positions are possible by putting the
knob anywhere between the high and the low flame
symbol.
To turn off the burner, turn the knob clockwise to the off
position " " .
Important:
• Do not activate the automatic ignition device for more
than 15 consecutive seconds.
• Difficulty in ignition is sometimes due to air inside the
gas duct.
• If a burner flame accidentally goes out, the gas continues
to exit for a few moments before the safety device
activates. Turn the control knob to the off position and
do not attempt ignition again for at least 1 minute, thereby
letting the gas disperse, which could otherwise be a
danger.
• When the equipment is not in operation, check that the
knobs are in the off position " " . The main gas supply
cut-off cock should also be closed.
•
Replace it in its housing in the position desired.
•
Make sure that the burners are positioned correctly
before use.
In addition, the two central burners can be used in tandem
or speartely with cookware of different shapes and sizes:
•
Double burner for a fish-kettle or oval cookware
(Fig. A).
•
Double burner for a griddle or rectangular/square
)
cookware with minimum dimensions of 28x28 cm
(Fig. B).
•
Double burner for large cookware (diameter of 26-28
cm) (Fig. C).
•
Single burner for medium size cookware (diameter of
16-20 cm) (Fig. D).
fig.A
fig.C
10
fig.B
fig.D
Werbung
Inhaltsverzeichnis
