Kaco blueplanet hybrid 6.0 NH3 M2 WM OD IIG0 Bedienungsanleitung Seite 5

Contents
1 Overview of connection area ........................... 3
2 Scope of delivery ............................................. 3
3 System wiring diagram .................................... 4
1 General information ........................................ 5
2 Safety .............................................................. 5
2.1 Intended use ...................................................... 5
1 EN- Contents
1 General information
This quick installation guide does not replace the description in the user manual.
The contents of this guide may be updated or revised due to device development. The information in this guide is subject to
change without notice. The latest version of this document and the manual for installation, commissioning, configuration
and decommissioning are to be found in PDF format at www.kaco-newenergy.com.
2 Safety
2.1 Intended use
The device is a transformerless hybrid inverter with 2 or 3 MPP trackers and a battery connection that feeds the direct
current of the PV array into the connected battery or converts it to grid-compliant three-phase current and then feeds it
into the utility grid. The device also can convert the direct current supplied by the battery into grid-compliant three-phase
current. The device has a backup function that can continue to supply selected circuits with power from the battery or PV
system in the event of a grid fault.
The device is intended for indoor and outdoor applications.
The device must only be connected with PV modules of protection class II (in accordance with IEC 61730, application class
A). Do not connect any sources of energy other than PV modules to the device.
The device is not equipped with an integrated transformer and therefore has no galvanic isolation. The device must not be
operated with PV modules which require functional grounding of either the positive or negative PV conductors. This can
cause the device to be irreparably damaged. The device may be operated with PV modules with frames that require
protective earthing.
All components must remain within their permitted operating ranges and their installation requirements at all times.
Use the device only in accordance with the information provided in the user manual and with the locally applicable
standards and directives. Any other application may cause personal injury or damage to property.
The device must only be operated in connection with an intrinsically safe lithium-ion battery approved by KACO. The entire
battery voltage range must be completely within the permissible input voltage range of the device.
The device must only be used in countries for which it is approved by KACO and the grid operator.
The type label must be permanently attached to the device and must be in a legible condition.
This document does not replace any regional, state, provincial, federal or national laws, regulations or standards that apply
to the installation, electrical safety and use of the device.
KACO blueplanet hybrid 6.0 NH3 M2 KACO blueplanet hybrid 8.0 NH3 M3 KACO blueplanet hybrid 10.0 NH3 M3 KACO blueplanet hybrid 12.0 NH3 M3
2.2 Important safety instructions ............................. 6
2.3 Symbols on the label .......................................... 8
3 Instructions ................................................... 73
4 Technical data ............................................... 87
4.1 Electrical data ................................................... 87
4.2 General data ..................................................... 88
4.3 Environmental data .......................................... 89
4.4 Requirement for supply lines and fuse ............. 89
Page 5