Pfannenberg PYRA PY L-S-TL Sicherheitshinweise / Kurzanleitung Seite 4

en
Electrical connection:
(Circuit board in the 1
Connecting terminal (X1)
AC: DC:
L/
Operating voltage
connection
N/
1 stage
st
2 stage
nd
3 rd stage
08/2024
stage/ in the lower sounder part)
st
X1 Operating voltage connection
X2 Plug connection light for com-
bined operation with sounder
X3 Plug connection sounder
X4 Plug connection 1
X5 Plug connection 2
X6 Plug connection 3
+
-
Optical Settings
Light intensity control
stage
st
stage
nd
stage
rd
Selection of
operating mode
(on the driver board in the upper sounder part)
DC version
3 stage
rd
2 stage
nd
1 st Stage
Tone selection switch
The desired tone can be selected using the tone selector switch S3.
The tone is generated after the supply voltage is applied. The possi-
ble tones are described in the tone type table in the Annex.
4/12
Quick guide PY L-S-TL/ PY L-S-TLA
(Circuit in the lens)
S1
Operating mode
1 2 3
OFF OFF OFF Flashing light 1 Hz
OFF OFF ON Flashing light 0.75 Hz
OFF ON OFF Continuous light
OFF ON ON Blinking light 1 Hz
ON OFF OFF Flashing light 2 Hz
ON OFF ON Blinking light 2 Hz
ON ON OFF Flashing light 0.1 Hz
ON ON ON Flashing light 0.5 Hz
*
Factory setting
Tone settings
AC version
Volume control
S3
Tone selection switch
*
086050012b