Silvercrest SSMC 600 B1 Bedienungsanleitung Seite 71

■ If this does not remove the dirt, you can remove the lower plastic part C of
the blender attachment 3 with the cutting blades 4 from the glass part A
of the blender 3:
Fig . 4
A Glass part
B Sealing ring
C Plastic part with blades
1) Remove the blender 3 from the motor unit 6 . For better stability, remove
the lid 2 by turning it anticlockwise towards position
you can pull it off upwards .
2) Turn the appliance upside down and turn the plastic part C of the
blender 3 anticlockwise so that it can be detached from the glass part A
of the blender attachment 3 (see fig . 4) .
3) Clean both parts in a mild soap solution or in the dishwasher .
4) You can carefully remove the sealing ring B from the plastic part C if
necessary . Clean in mild soapy water and rinse with clear water .
5) Dry all parts thoroughly before reassembling them .
6) If necessary, reinsert the sealing ring B into the plastic part C correctly .
Then place the plastic part C of the blender 3 back on the glass part A
of the blender 3 and turn the plastic part C clockwise .
■ 68 │ GB │ MT
C
B
A
(see Fig 1) until
SSMC 600 B1