Herunterladen Diese Seite drucken

Parkside PSSFS 3 A2 Bedienungs- Und Sicherheitshinweise Seite 15

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Issue
The display needle 
jumps to the highest value
of the display scale 
The display needle is
always jumping to highest
value of the display scale .
The display needle 
cannot be aligned with the
middle part of the display
scale 
.
1 ]
[
6 . Point the satellite antenna in a rough direction towards the desired satellite .
NOTE: Read the instruction manual of the satellite antenna or perform research
on correct values for the height and side angle required for adjusting the satellite
antenna .
7 . Rotate the control knob
part of the display scale
acoustic signal, the better the antenna is aligned towards the satellite .
Potential cause
The receiver signal is too
[
6 ]
high for the product .
.
[
1 ]
The connected LNB is
a high capacity type
with high amplification
(> 60 dB) ./The connected
[
6 ]
satellite antenna is larger
than 1 metre .
until the display needle
[
3 ]
. The buzzer
[
1 ]
Solution
Reduce the sensitivity of the
product: Turn the control
knob
until the display needle 
is aligned with the middle
part of the display
scale 
Insert an attenuation
controller (0–20 dB)
between the LNB and the
product .
is aligned with the middle
[
6 ]
emits an acoustic signal . The higher the
[
7 ]
counter‑clockwise
3 ]
[
6 ]
[
.
1 ]
[
GB/IE/NI
13

Werbung

loading

Diese Anleitung auch für:

Hg06986b449831 2310