cecotec BELLECOUTURE OVERLOCK Bedienungsanleitung Seite 43

ENGLISH
Thread the threads as shown in steps 1-4 in the picture below:
The colour codes are applied as follows:
1. Upper looper thread: pink
2. Lower looper thread: yellow
3. Right needle thread: green
4. Left needle thread: blue
Threading the thread guides
Place the spools on the spool pins. Use the cone holders only with spools that also have that shape. Insert the threads through the thread guides
from the back to the front following the colour codes.
Raise the handle. Insert the threads under the handle and through the rear thread guides by pulling downwards with both hands until the thread
slides under the thread guides. Then, pass the thread between the tension discs and press it downwards until it is lodged between these tension
discs. Lower the handle back down.
43
BELLECOUTURE OVERLOCK