Operation; Synchronising Transmitter / Receiver; Setting The Signal Type - Silvercrest Z31370A Bedienungshinweise Und Sicherheitshinweise

Operation

Synchronising transmitter / receiver

Synchronise the transmitter and receiver as follows:
As soon as the batteries are installed, the receiver enters synchronis-
ing mode.
You can also manually enter synchronising mode by holding the
synchronising button
The signal indicator
Press the chime button
will illuminate once.
The signal indicator
cate the synchronisation is successful.
NOTE: The synchronisation mode can only last for approx. 2 minute. If
you cannot synchronise your transmitter and receiver, please enter syn-
chronising mode again.

Setting the signal type

The receiver can indicate the reception of a door signal either optically
or acoustically or both optically and acoustically.
for approx. 3 seconds.
2
on the receiver will light on.
1
, the signal indicator
13
on the receiver will then blink. This is to indi-
1
Operation
on the transmitter
11
GB/IE 15