Revitive Medic Plus Knee Bedienungsanleitung Seite 12

Instructions for use
j
Press the
7 0
Continue to increase the intensity until you can feel the stimulation.
3o
You can set the intensity between 1-99.
You can use the buttons on the device or remote control.
Press the (+) button to increase the level.
Press the (–) button to decrease the level.
It is normal to feel tingling or varying sensations in the muscles you are treating.
Please note that the intensity required may vary from day to day.
If you feel pain or discomfort:
• Lower the intensity of the Electrode Pads using the
• You can also choose to stop therapy before the end of the default session to avoid skin irritation and/or
muscle fatigue. You can do this by pressing the
k
The Time display will start to count down in minutes as Revitive cycles
through its program.
When Revitive times out, you will hear three beeps, and the device will switch
itself off automatically.
l
Ensuring that the device is switched off, gently peel the Electrode Pads from the
skin.
Do not pull the Electrode Pads off the skin using the Electrode cords as this
may damage the cords.
m
Replace the Electrode Pads onto their plastic liner after use.
n
Unplug the Electrode cord from the socket on Revitive.
o
The stimulation can be paused if necessary by unplugging the electrode cord from
Revitive or from the pads. Revitive will pause for up to 10 minutes during which
time you can re-connect and press
After 10 minutes of being in the paused state, Revitive will switch itself off.
22
7377_IFU01_19015432.indd 22-23 7377_IFU01_19015432.indd 22-23
(+) Intensity Control once to start stimulation.
(–) Intensity Control on the device or remote control.
power button on the device or on the remote control.
(+) to re-start the stimulation.
Step 4.1: Switching between EMS and TENS mode
To change between EMS and TENS mode, press the button of the stimulation mode you require on the remote
control.
You will see the mode selected highlighted on the display.
During use, switching from EMS to TENS mode (or vice versa), will reset the timer back to the relevant default time.
The intensity will also be reset to zero.
0 0
2o
EN
0 0
3o
23
08/02/2023 12:52 08/02/2023 12:52