Record; Record With The Built-In Microphone - Philips LFH 7780 Benutzerhandbuch

Slide the HOLD switch to the Off position to enable the buttons
1
on the Voice Tracer.


Record

• Press the REPEAT/FOLDER button to select the desired folder.
The Voice Tracer will move to the next folder each time you press
the button.
• Set the desired voice activation function and quality (Super HQ,
HQ, SP, LP, SLP) before you start recording (see the Menu chapter
for more details).
• Make a test recording to make sure that the Voice Tracer settings
are correct.
• Press and hold the PLAY/PAUSE button during recording for a few
moments to display the remaining recording capacity.
• The maximum number of files in each folder is 99, for a total
capacity of 396 files (99 files x 4 folders).
• If the recording time exceeds the available capacity or
the number of files reaches 396, "FULL" will be displayed
and recording cannot be continued
delete a few recordings or move them to an external
device (audio or computer).
• Do not remove the batteries during recording. This may

1 2 . If this happens,
cause the Voice Tracer to malfunction.
• If recording for a prolonged period of time, replace the
batteries before beginning.
• When the Voice Tracer is in voice activation mode
will stop automatically when no sound is detected. Disable the
function when recording important conversations.
• Press the REC button while playing back an MP3 or WMA file in
the M (Music) folder to enable the equalizer.
3.1 Record With the Built-in Microphone
1 Press and hold the REC/PAUSE button for a moment to switch
the Voice Tracer on and start recording
light.
Point the Voice Tracer's built-in microphone towards the sound
2
source. Press and hold the PLAY/PAUSE button during recording
to display the remaining recording capacity.
Press the REC/PAUSE button to pause the recording. The
3
red LED will blink, and "Pause" will flash on the display.
4 Press the REC/PAUSE button again to resume
1
recording. The red LED will light again.
Press the NEXT button to create a new file during
5
recording (file separation function).
2
The total time of the recording is displayed when you
6
stop recording by pressing the STOP/MENU button
3
3 , recording
1 2 . The red LED will
1
2
3
3 .
User manual