HOMCOM 820-083 Montageanweisungen Seite 4

• The control switch at the OFF position when first operation.
• Rotate control switch clockwise through the three settings.
• Switch on electricity
• Switch on low heat setting at 900W position.
• Switch on high heat setting at 1800W position.
• Rotate control switch anticlockwise
• This heater has a adjustable thermostat
clockwise or anti-clockwise
Note: The thermostat
820-0861820-0871820-1781820-299V90:
The following switches are located at back of the heater.
Insert plug into mains socket
Select the desired functions:
• Switch 2 (0/1 ) Switchs on/off electricity supply to the heater and flame effect
• Note: This switch must be in the ON (l) position for heater to operate with or without heat
• Switch 3 ( I ) Switchs on/off 1000W heat output
• Switch 4 ( II ) Switchs on/off 2000W heat output with switch 3.
• Note: The flame effect can be operated with or without heat.
Rotate thermostat knob (I ) clockwise or anti-clockwise
room temperature setting.
Safety Cut-Off
This appliance is fitted with a safety cut-off which will operate if the heater overheats
Due to blocked air vents). For safety reasons, the heater will NOT automatically
reset the appliance, disconnect
minutes. Reconnect the supply to the mains and switch on the appliance.
supply to the heater and flame effect at ON position
to switch off the settings accordingly.
to set desired room temperature.
to achieve desired room temperature
is located on the back
2 3 4
the appliance from the mains supply for at least 15
of the heater.
to increase or decrease desired
4
Rotate
setting.
(e.g.
reset. To