SHX SHXP2200PTC Bedienungsanleitung Seite 211

In heating mode: Press arrow buttons 4 and 6 to select the desired heating level
between 1 and 4.
Automatic mode: In cooling mode: Press the Auto mode button 5 to switch to
Auto mode. The Auto mode indicator 12 lights up and the appliance operates in the
first stage.
In heating mode: Press the Auto mode button 5 to switch to Auto mode. The Auto
mode indicator 12 lights up and the appliance operates at a constant temperature
(factory preset temperature is 26°C).
Turbo mode selection: In cooling/heating mode: Press the Boost button 7 to set
the cooling/heating output to maximum.
Set the temperature: Press the increase/decrease buttons 8, 9 to set the working
temperature. The setting is activated when the display 12 flashes and the
temperature display 17 lights up. Select the desired temperature by pressing
buttons 8, 9. Wait 5 seconds, the appliance automatically saves the settings and
starts working, with the current temperature shown on the display.
Switch off: Press button 10 to switch off the appliance.
Operation
Before the first operation
•
Carefully remove the appliance from the box and place it on a flat surface.
Please keep the box for out-of-season storage.
•
Make sure that the power switch is in the OFF position before connecting
the appliance.
•
Ideally, do not use the same socket as other high-power electrical
appliances to avoid overloading the circuit. Insert the mains plug into a
220-240V~/50Hz/10A standard safety socket.
•
Switch on
•
Insert the plug and switch on the mains switch. The appliance is in standby
mode with a short acoustic signal. Press the On/Off button 10 to switch the
appliance on. The display shows the current room temperature after all
indicator lamps are switched on and goes out.
211