Virutex FR156N Gebrauchsanweisung Seite 8

para informarse sobre cómo y dónde pueden llevarlo
para que sea sometido a un reciclaje ecológico y seguro.
VIRUTEX se reserva el derecho de modificar sus productos
sin previo aviso.
E N G L I S H
FR156N/FR256N TRIMMER
Important
Read these OPERATING INSTRUCTIONS
and the attached GENERAL SAFETY
INSTRUCTIONS LEAFLET carefully before
using the machine. Make sure you have
understood them before operating the
machine for the first time.
Keep both sets of instructions for any
future queries.
1. SAFETY INSTRUCTIONS
FOR THE TRIMMER USE
Carefully read the GENERAL SAFETY
INSTRUCTION LEAFLET enclosed with the
machine documents.
1. Supply voltage must be the same as that indicated
on the specifications plate.
2. Keep hands away from the cutting area. Hold firmly
the machine when working.
3. Use always Virutex original bits. Never use malformed
or broken bits.
4. Always use bits with the correct size of shank for the
chuck being used and adjust the velocity of the tool.
Unplug the machine from the electrical
outlet before carrying out any handling
operations.
5. The brake pivot R (Fig. 8) must be placed on the front
(not the edge) of the bit bearing.
2. SPECIFICATIONS
Input power.....................................................1000 W
No-load speed...........................14000-30000/min
Chuck collet................................................8 mm
Weight........................................................1,6 Kg
Weighted equivalent continuous
8
acoustic pressure level A..................................................88 dBA
Acoustic power level A.......................................................99 dBA
Uncertainty...................................................................K = 3 dbA
Wear ear protection!
Vibration total values.................................................a
Uncertainty....................................................................K: 1.5 m/s
3. STANDARD EQUIPMENT
Inside the box you will find the following items:
Model FR156N
Trimmer FR156N fitted with:
• Round trimming head (V3) 5646365. Attached.
• Corner rounding bit 2 with bearing HM 1140123.
• A/f key: 11 mm for the motor shaft.
• A/f key: 19 mm for the chuck collet.
• Head bases with a pitch diameter of 30.
Model FR256N Set
Trimmer FR156N fitted with:
• Trimming head CA56U 5600060. Attached.
• Round trimming head (V3) 5646365.
• Corner rounding bit 2 with bearing HM 1140123.
• A/f key: 11 mm for the motor shaft.
• A/f key: 19 mm for the chuck collet.
• Head bases with a pitch diameter of 30.
• Dust extraction adapter support (for edge profiling
on a workbench).
• Protection for securing the head on a workbench.
4. GENERAL DESCRIPTION
OF THE FR156N TRIMMER
The main function of the machine is the finishing of PVC,
melamine and wooden edges. These may be straight and
angled or curved, depending on the bit used. Shaped
finishes can also be obtained using different VIRUTEX
bits with bearings.
It is possible to secure the head on a horizontal surface
for beveling and/or rounding the edges of the banded
workpiece on small or small-format pieces.
The machine is equipped with a suction port,
which MUST BE CONNECTED MANDATORILY using the
Standard dust collector attachment (Ref. 6446073) to
our vacuum cleaners AS182K, AS282K, or any industrial
vacuum cleaner. Failure to comply with this action can
cause damage to the machine; blocking and breaking
-1
of the bearing follower of the cutter, as well as poor
workmanship.
The dust collector connection incorporates a sprung
brake pivot R (Fig. 8), whose purpose is to slow down
: 2.6 m/s
2
h
2