Cleaning And Care - Parkside Plsa 20 Li B2 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

Place the solder
tip to melt.
[ ]
Keep feeding solder
Withdraw the soldering tip
solder from overheating.
Allow the solder to harden. Avoid any knocks or vibrations.
NOTE
The flux is either included in the solder or applied separately.
u
When you buy the solder, ask about the kind of applications it
is suitable for and the appropriate flux.
˜ Cleaning and care
˜ Cleaning
m WARNING! RISK OF INJURY!
Always remove the battery
u
down before you carry out any work on the product.
Always clean the product after completion of work.
To clean the housing, use a cloth and a mild detergent if
necessary.
Never use sharp objects, petrol, solvents or cleaning agents that
can damage plastic.
Do not allow any liquids to get into the interior of the product.
34 GB/IE
between the soldering location and soldering
[ ]
until the entire solder joint is covered.
[ ]
immediately to prevent the molten
[ ]
and allow the product to cool
5 ] [