Auxiliary Input; Bluetooth Operation; Troubleshooting - Thomson Ws302 Bedienungsanleitung

1. Bass control
2. Treble control
3. Master volume/Mode control
4. LED indicator
5. On/Off switch
6. Power port
7. Aux in input port

Auxiliary input

1. Press the Mode/Volume button to select an auxiliary input. The light should turn pale
green.
2. Use the appropriate AUX cable to connect an audio source to the speakers.
3. Play music from your connected device and adjust the volume on your device by turning
the Mode/Volume button.

Bluetooth operation

1. Switch on the speaker and go into Bluetooth mode by pressing the Mode/Volume button
on the upper panel of the active speaker. The light will turn blue.
2. Access the "Settings" section of your source device (mobile phone, tablet, etc.) and
search for nearby Bluetooth devices: You will find "WS302" in the list.
3. Pair your device with "WS302".
4. Play the audio tracks on your device and adjust the volume according to preference.
5. Press and hold the Mode/Volume button to disconnect the Bluetooth.
Comment: The maximum connection range is approximately 10 metres. Place your Bluetooth
speaker as close as possible to the device to avoid any interference with the connection.

Troubleshooting

Problem
No sound
Unable to connect
via Bluetooth
Check that the power indicator is ON.
Try increasing the volume using the main volume control.
Make sure the audio cables are securely connected and the input is
properly set to the speakers.
Check if there is an output signal from the audio source.
Make sure that the speaker is set to Bluetooth input; Bluetooth
cannot connect.
Disconnect any Bluetooth device by pressing and holding the Mode/
Volume button.
- EN 13 -
Solution