Emerio PO-132101.1 Bedienungsanleitung Seite 7

Important!
1. If you want to use an extra baking tray, baking dish, etc. not supplied with this appliance, please put it onto
the pizza stone and preheat together beforehand. Make sure the baking tray is smaller than 32*32cm and
can withstand high temperatures of at least 430℃.
2. Only under the menu program "DIY", users can cancel the preheat function by long pressing the button
" " until a beep sound is heard, and then press the button "
will show countdown of the cooking time immediately. For this, please put the food together with the pizza
stone into the cooking chamber beforehand. For other menu programs the preheat function cannot be
cancelled.
3. Only under the menu program "DIY", users can cancel either upper or lower heating element by pressing the
button " " or "
simultaneously by default and cannot be changed.
4. This appliance is equipped with a memory function. The set temperature and time will be saved before the
appliance is turned off and the device will be able to operate with the same settings after it is turned on
again.
5. This appliance is also equipped with a reset function to restore the default temperature and time for each
menu program. Long press the location where the button "
and other indicators off). The buzzer will send out 3 beeps to indicate that the appliance is reset now.
CLEANING AND MAINTENANCE
1. Always unplug the appliance and make sure the oven is disconnected from the power source before
performing any cleaning or maintenance.
2. Allow the hot appliance to cool down at least 30 minutes before cleaning and storing.
3. Wipe the machine body only with a damp cloth or non-abrasive sponge.
4. Rinse the pizza stone with clean water, scrape off any residues and air dry thoroughly.
5. Rinse the pizza peel with clean water. The pizza peel body can be detached off and cleaned in a dishwasher.
Do not put any other parts in the dishwasher.
6. Use a brush to clean the residues on the upper and lower heating elements.
ERROR CODES
Please contact our service department when error codes show up as follows.
E1 Thermocouple over temperature, NTC fault protection
E2 Thermocouple open circuit fault protection
E3 Thermocouple no calibration or calibration failure
E5 Communication failure between display PCB and power PCB
TECHNICAL DATA
Operating voltage: 220-240V ~ 50-60Hz
Power: 2200W
". For other menu programs the upper and lower heating elements work
" to start the appliance. The digital display
" is under standby mode (with "
- 6 -
" flashing