Frigelux CA155BDS Gebrauchsanweisung Seite 23

N-ST: This refrigeration appliance is intended for use at ambient temperatures between 16°C and
38°C.
Avoid placing your freezer near a heat source, for example, stove, boiler or radiator. So, avoid direct
sunlight over-buildings or deckchairs. Make sure that the freezer is not placed near humidity (tumble
dryer for example) otherwise condensation will occur on the cabinet. Never place the freezer in a
wall or built into built-in cabinets or furniture. When your freezer is running, the rack at the back may
become hot and the sides hot. Therefore, it must be installed leaving at least 10 cm of free space at
the back, 30 cm above and 10 cm on the sides.
Leveling the freezer
If the freezer is not level, the door seal and magnetic alignment will be
affected. Once the freezer is placed in its final location, adjust the front
adjustable feet by turning them. Make sure the foot touches the ground
before use. Look down from the top, loosen clockwise and
counterclockwise tighten.
Cleaning before first use
Wipe the inside of the appliance with soapy water. Then rinse with lukewarm water using a sponge
or cloth. Wash drawers and flaps in warm soapy water and dry them completely before replacing
them in the appliance. Clean the exterior of the device with a damp cloth.
If you need more information, see the cleaning section.
Before plugging in your device
Check that you have an outlet that is compatible with the plug supplied with the freezer. If not see
section titled ELECTRICAL INFORMATION.
DO NOT START UP FOR FOUR HOURS AFTER THE UNIT HAS BEEN MOVED.
The coolant needs time to settle. If the unit is turned off at any time, wait 30 minutes before plugging
it back in to allow the coolant to properly replenish.
Before filling the device
Before storing food in your freezer, plug it in and wait for 4 hours to make sure it is working properly.
4. OPERATING YOUR APPLIANCE
Temperature setting
The temperature control knob of your appliance is located behind the appliance, at the bottom.
The first time you put your appliance into operation, set the thermostat to "3" and let it run empty for
4 hours before storing food for it to cool sufficiently.
23