Silvercrest COOK 'N' MIX Bedienungsanleitung Seite 11

NOTE
► If the consistency of the compote is still too
chunky, you can puree the content a little after
the programme finishes until you achieve the
desired consistency: Use the MIXER function
z (see section "Blending") to do this .
If you have previously used the KOMPOTT
r programme beforehand, it is not abso-
lutely necessary that the fill level is above the
MIN marking when you carry out additional
pureeing .
Please make sure that the fill level is above
the MIN marking for all other purposes,
however .
8) Remove the plug from the mains power socket
and the connector 3 from the built-in plug 4 .
9) Remove the lid 9 carefully from the blender
jug 5 and place it to one side .
WARNING! RISK OF INJURY!
► Be careful when opening the lid 9 .
Hot vapour can escape! We recommend the
use of oven gloves .
You can now serve the compote in dishes or a
bowl .
NOTE
► Clean the appliance after every use (see
section "Cleaning and care") . Otherwise resi-
dues from the previous cooking process that
may be left on the bottom of the container
could burn .
Preparing smoothies/milkshakes
1) Cut the fruit/vegetables into pieces of around
2 cm and place these in the blender jug 5 .
2) Fill the blender jug 5 up to no more than the
MAX - 1600 ml marking with liquids . Always
fill up to at least the MIN - 1300 ml marking!
■ 8 │ GB │ IE
3) Place the lid 9 on the blender jug 5 . Ensure
that the contact plug 1 in the lid 9 fits cor-
rectly in the safety socket 2 .
4) Insert the connector 3 into the built-in plug 4
on the appliance .
5) Insert the plug into a mains power socket . You
will hear a beep and the programme indicators
flash .
6) Press the MODE button q repeatedly until the
SMOOTHIE programme indicator
to flash .
7) Press the START/STOP button i . You will hear
a beep and the SMOOTHIE programme indi-
cator t flashes .
Preparation of the drink now takes place automati-
cally . The programme runs for 2 minutes .
NOTE
► You can stop the preparation process at any
time by pressing the START/STOP button i
(for about 2 seconds, until you hear a beep) .
As soon as the preparation process is complete,
the appliance will stop automatically . You will hear
a beep and the SMOOTHIE indicator light
flashes .
8) Remove the plug from the mains power socket
and the connector 3 from the built-in plug 4 .
9) Remove the lid 9 from the blender jug 5 and
place it to one side .
You can now serve the smoothie/milkshake .
t starts
t