x-sense XS01-WX Bedienungsanleitung Seite 7

CEILING
NEVER
NOT IN
THIS AREA
N THIS AREA
190
MAXIMUM
SIDEWALL
THIS AREA
AN"NHERE
IN THIS AREA
Installation Procedures
Before installation, you wi need to test the alarm, making sure it is
functioning properly within the router's range.Then, install the alarm as
follows:
1. Mark holes on the ceiling or wall using the mounting bracket asa
guide.
2, Drill holes at the two marked positions with a drill bit, Insert the anchor
plugs, then attach the mounting bracket using the provided screws.
3. Attach the alarm to the mounting bracket,then turn clockwise to Ock
the alarm.
4 Test the alarm by pressing the Test/SiIence button. It should flash red
three times with three short beeps,and then flash blue,
4)