SkyLine Racer Handbuch Seite 29

Adjusting the shoulder belt
buckles:
The setting of the shoulder belts
is to made sitting in the harness
at the simulator by the adjusting
the trimmers, which are at the
shoulder. The shoulder belts are
conceived as "free-sliding" belts
with "chain-block" system for an
optimum leeway and for fast
longer
change from upright to supine
position.
Note: with the correct adjustment, the
shoulder belts fit to your shoulders with a
light pressure. This means that the pilot
feels a bit harder pressure on his shoulders
in upright position.
Adjusting the leg
loops:Adjusting the leg loops
takes place each time again when
putting on the harness. You have
to pay attention to always
shorter
tightening the leg loops firmly. You
can vary the position of the leg
loops by adjusting the buckles of
loose
the belts under the seatboard
(accessible via velcro-closed
opening at the front of seat area).
Note: You always have to pay attention to
the correct engaging of the clicking
latches! Tighten the leg loops again before
launching, so that the seat board remains
tight
fixed within the range the thigh. They
prevent thereby the sliding-up of the
seatboard and to get faster in a seating
position.
5 5
skyline-flightgear.de