Ace instruments Aceprotec FT-SH-02 Benutzerhandbuch Seite 7

Connection Instructions
Energy-absorbing lanyards with a shock pack must be connected with the energy-absorbing end of the lanyard
connected to the dorsal D-ring of the full-body harness. The opposing end of the lanyard Is to be connected to
the anchorage connector. Frontal D-rings are for rescue work only (used as a pair), do not attach frontal D-rings
to fall arresters!
Inspection, Cleaning & Storage
Information about inspection records can be found in the inspection and maintenance log on the reverse of
this sheet.
Life: The use cycle is three years and needs to be checked before each use
Transport: The harness should be placed in a sealed bag and then put in a suitable carton to transport.
Inspection: Harnesses must be inspected on an annual basis by a qualified inspector. This person shall decide
whether the harness has to be removed from service or not. During the course of work, all reasonable efforts
should be made to ensure that the harness is protected from potential damage, i.e.: cuts, burns, caustic chemical
exposure, abrasive elements, etc. If the harness is used in an environment where dangers such as this are
prevalent, the harness should be inspected for damage both before and after use.
Cleaning: Harnesses may be cleaned with household grade soap and water. Do not use acidic or basic solvents
(caustic soda). Allow harnesses to dry in a ventilated room far from heat sources and away from direct sunlight.
Maintenance: Personal Energy Absorbers and Energy-Absorbing Lanyards requiring maintenance must be
tagged "unusable" and removed from service.
Cleaning and maintenance may be performed by the user.
Snap hooks and carabiners may require periodic lubrication. Do not apply oil, grease, or other contaminants on
the lanyard. Use a dry lubricant that has proper resistance to temperature extremes, moisture, and corrosion.
Do not over-lubricate.
Storage: When not in use, Personal Energy Absorbers and Energy-Absorbing Lanyards should be stored in a
cool, dry place out of direct sunlight. Do not store in areas where damage from environmental factors such as
heat, light, excessive moisture, oil, chemicals, and their vapours, or other degrading elements may be present.
Do not store damaged equipment or equipment in need of maintenance in the same area as a product
approved for use. Equipment must be cleaned and dried prior to storage. Equipment that has been stored
for an extended period must be inspected as described in these User Instructions prior to use.
12
Specifications
Materials: safety lanyard and energy absorber may be constructed of one or a combination of the following
Materials: Nylon, polyester, polyamide, meets EN361:2002 requirements.
Connectors: forged or stamped steel, meets EN362:2004 requirements
Product Labelling
Labels must be present, attached to the harness, and fully legible:
on the full-body harness, a pictogram to indicate that users shall read the information supplied
by the manufacturer
a capital letter „A" at each fall arrest attachment element
the model/type identification mark of the energy absorber: FT-SH-02
the number of this European standard, i.e. EN 361
Risk Against which the Safety Lanyard is designed to protect
PPE equipment designed to protect professionals from risks associated with a fall from height make up part of
Category III: Protection against mortal dangers or dangers which could seriously and irreversibly damage health
or those whose effects cannot be ascertained at the appropriate time.
Notified Body (2021)
CCQS Certification Services Limited, Ballycoolin Road, D15 AKK1 Dublin, Ireland, notified body: 2834
13