Ace instruments Aceprotec FT-SH-02 Benutzerhandbuch Seite 5

Full-Body Safety Harness
Tectum / Certum, Model: FT-SH-02 / Standard: BS-EN361: 2002
This model meets the requirements of EU Regulation 2016/425. The declaration of
conformity can be found here: www.ace-technik.com/content/6159.html
User's Instruction Manual – EN
Instructions for Use
Note: You must read and understand or have the following instructions explained to you before using this
equipment. Failure to do so could result in injury or death.
The correct combination and use of our safety equipment are designed to offer you maximum height safety
protection. The proper fit and attachment of full-body harnesses and shock absorber with lanyard are critical for
reducing the likelihood of body damage or system failure when using a compliant fall protection system. Users
must be trained and knowledgeable in the proper fit.
Harness Components
1
5
2
3
3
8
4
1. Shoulder straps
2. Chest strap
3. Parachute / tongue buckle / quick-connect fastener
4. Thigh straps
5. Torso adjustment
6. Dorsal-D-ring
7. Back plaque
8. Sub-pelvic strap
9. Stitched effect indicator
10. Label
6
7
9
10
8
Putting on the Harness
Step 1 Step 2
Grasp the harness by the dorsal Slip on the shoulder straps one at
D-ring and shake until straps hang a time as if you were putting on a
down from the harness body. Make jacket. Be careful not to twist the
sure, that the buckles are not straps.
fastened.
Step 4 Step 5
Individually adjust each shoulder Pull each thigh strap through the crotch and fasten the parachute
strap by pulling or releasing the buckles by passing the male buckle through the female. For the tongue
slack end so that the sub-pelvic buckle insert the grommeted strap through the buckle. Fasten by
strap is firmly in place under the inserting the tongue through the grommet. For quick-connect, insert
buttocks. male end into female end and apply pressure until the locking tabs
snap into place. Ensure closure by checking tab positions in buckle
window. Be careful not to cross or twist the strap.
Step 6
Adjust the tension of the thigh straps by pulling or releasing the slack end of the strap. Move the plastic clip
away from the edge of the buckle to adjust accordingly. For the tongue buckles, select desired grommet and
secure excess webbing under plastic clip. Proper tension is a 2-finger space between strap and leg.
Step 7
Position the plastic strap keepers so that one is next to the parachute buckle and the other is at the far end of
the excess strap. Be certain that the torso straps are adjusted so that the dorsal D-ring is in the centre of the
wearer's back.
Step 3
Attach the cheast strap
parachute buckle and adjust
the length so that the shoulder
straps are contered on each
shoulder.
9