Werbung
Mounting
Figure 5:
Accessories included in the scope of delivery
1 Dehumidifier
3 Stainless steel screw
5 Wheel
7 Screw nut
For the assembly is needed:
Screwdriver
Assembly steps for the ITR 90:
C) Preparation
a. Remove the dehumidifier from the packaging and check it for damage
b. Check the accessories (mounting set) for
c. Prepare the tools required for the assembly.
D) Mounting (see figure 5)
a. Mount the transport handle (2) using the 4 stainless steel screws (3), according to
Figure 5.
Allow the unit to stand in its final, upright position for at least 24 hours before
starting it for the first time.
Always operate the device in an upright position only and do not tilt it during
operation.
EN-10
2 Transport handle
4 Spacer washer
6 Spacer washer
8 Stand
completeness.
www.comedes.com
Werbung
