Silvercrest SHBS 3.7 C2 Bedienungsanleitung Seite 45

6.2 Changing the cutting attachments
WARNING! Risk of injury!
Switch off the hair and beard trimmer 5, before you attach
or remove the attachments.
• Figure A: to remove the attachments 3, 4, 12, 13, 14 use
your thumbs to press the attachment towards the rear of the
hair and beard trimmer 5.
• Figure B: to attach the attachments, put the lower flap of
the attachment 3, 4, 12, 13, 14 into the slot in the hair
and beard trimmer 5 and press the upper part of the attach-
ment against the hair and beard trimmer until it audibly locks
into place and sits firmly in position.
6.3 Changing the comb attachments
Pushing on
• To attach the comb attachments 2 + 1 carefully slide the ap-
propriate comb attachment over the hair or beard trimmer at-
tachment 13 / 14. Press the lower part of the comb
attachments 2 firmly until they lock into place.
Removing
• To remove the comb attachments 2 loosen the comb attach-
ment at its lower end and pull it off the hair and beard trim-
mer 5.
• Slide the comb attachment 1 for the beard trimmer attach-
ment 14 upwards from the hair and beard trimmer 5.
43
GB