Inhaltsverzeichnis
Werbung
Register Function values
CV58
Pause time (analog operation)
(0.5 seconds x function value)
When the polarity of the analog track voltage is
reversed, the loco waits for the programmed time
period, then accelerates in the new direction
CV60
Back-EMF: Max. adjustment factor
Specifies the max. increase or decrease of voltage
applied during each time interval (programmed in CV61)
1 = small steps, 255 = large steps
The factory pre-set values of CV60 and CV61 are
optimized for LGB motors.
CV61
Back-EMF: Adjustment frequency
Specifies how often per second the motor voltage is
adjusted - accordingly, the loco will react to curves
and grades immediately or with a short delay
0 = immediate adjustment, 255 = maximum delay
CV62
Back-EMF: Max. Adjustment
Limits the total adjustment in motor voltage. If there
is a very large load on the motor, the adjustment will
not exceed this value - for more realistic operations,
so that locos will slow a bit on grades.
0 = no adjustment, 255 = maximum adjustment
CV67
Speed steps programmed by user (see CV29):
to
28 speed steps are programmed in CV67 to CV94.
CV94
With LGB MTS, every second value is skipped
(14 speed steps). Factory pre-set speed steps:
7, 9, 11, 13, 16, 20, 24, 28, 32, 36, 42, 48, 54, 60, 68, 76,
84, 92, 102, 112, 124, 136, 152, 168, 188, 208, 230, 255
Pre-set values for user-programmable speed steps:
8, 16, 24, 32, 40, 48, 56, 64, 72, 80, 88, 96, 104, 112,
120, 128, 136, 144, 152, 160, 168, 176, 184, 192, 208,
224, 240, 255
Hint: The speed steps are factory pre-set and program-
ming is not necessary. We recommend the 55045 MTS
PC Decoder Programming Module for programming.
Available Factory
pre-set
(0-255)
[0]
(1-255)
[10]
(0-255)
[5]
(0-255)
[255]
(0-255)
Werbung
Inhaltsverzeichnis
