Operation; Changing Battery - Homematic Hmip-Krc Bedienungsanleitung

6

Operation

Once you have taught-in the Homematic IP Key Ring Re-
mote Control, you can control other devices easily using
two pairs of buttons (button pair 1 and button pair 2). The
buttons of each pair represent a single unit for the device
you wish to control using the key ring remote control.
For example, you can use the first button pair (B and C)
to switch a lighting actuator on or off, and use the sec-
ond button pair (D and E) to move shutter actuators up
or down.
7

Changing battery

If the battery symbol is displayed via the app or an emp-
ty battery is indicated on the device (see sec. "8.4 Error
codes and flashing sequences" on page 33), replace
the used battery by a new LR03/micro/AAA battery. You
must observe the correct battery polarity.
To replace the battery of the key ring remote control,
please proceed as follows:
• Open the battery compartment (G) at the rear
by pushing the battery compartment cover away
from the device. You will need to apply some
pressure to do this (see figure 2).
• This will open the catch; you can then swing
open the battery compartment cover. The cover
will stay connected to the housing.
Operation
29