Markibar IZAGA Betriebsanleitung Seite 30

1.- Safety instructions.
Please read and pay close attention to the following safety instructions.
The failure to follow these instructions may result in a malfunction or
damage to the machine.
1.1- Symbols.
1.1-1.Safety instructions.
Risk of an accident if this note is not followed.
1.1-2.General instruction.
The machine may be damaged or proper operation
is no longer guaranteed if this instruction is not followed.
.
1.2- Safety instructions.
The power plug supplied by the manufacturer shall
.
correspond to the country where the machine is installed.
When unpacking the machine, check to see that the voltage
of your electrical system matches that shown by the
manufacturer on the rating label. Never use the machine in
.
wet or damp areas.
The plastic bags used for packing may pose a safety hazard.
.
Keep them out of the reach of children.
Unplug the equipment before performing any maintenance
.
or cleaning tasks.
Never operate the grinder if the electrical cord is in poor
condition. Periodically inspect the electrical cord, the plug,
.
etc. for any possible damage.
Any repair should be performed by Authorized Service
.
Technicians.
For best results, the maximum operating cycle should not
exceed 5 seconds of grinding and 10 seconds of stoppage.
After 30 minutes of continuous operation, allow the motor to
.
cool down 30 minutes before using it again.
Do no modify or alter the machine in any way. The
Manufacturer assumes no responsibility for damage caused
.
by the failure to follow these instructions.
This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental
30